Onkyo & Integra Control Software
- This topic has 0 replies, 1 voice, and was last updated 13 years, 7 months ago by
.
-
Topic
-
Hi Everyone
I have managed to get hold of some special control software for our AVR’s and Preamp, I have included 3 versions of this 2009/2010/2011.
The software allows you to configure the AVR without going any where near the actual unit itself !! and it allows you to save all of the settings to a file .The Onkyo support is limited to the Pre-amps only, But the Integra is fully catered for. To find out the supported models run in stand alone mode first. You may also need to go and get some dotnet updates/downdates. But best of all this software allows for full gamma control on the inputs and outputs & can be done via a network connection.
NOW I have not been told I cannot distribute this software but please do not let it out into the public sector, just keep it low key , I am doing this because I know its gonna help people here ( if you install/sell Onkyo/Integra), any questions email me directly mark.cheffins@eu.onkyo.com
- You must be logged in to reply to this topic.
