*RULES FOR THIS SECTION – FAQ*

*RULES FOR THIS SECTION – FAQ*

Home Forums Service Menu Access Info – All Users *RULES FOR THIS SECTION – FAQ*

  • Creator
    Topic
  • #133
    Anonymous
    Inactive

    Greetings

    Please do not post code requests here. Put them elsewhere and we will then post the info here (in alphabetical order).
    If you post here, I will move it to one of these areas or delete the post.

    Thanks for your cooperation.

    Regards

    above edited by Gregg

Viewing 7 replies - 1 through 7 (of 7 total)
  • Author
    Replies
  • #837
    Anonymous
    Inactive

    Michael,

    Does this really make sense for this forum?

    #826
    Gregg Loewen
    Keymaster

    hi Alan…

    yes it does…except for the gear choices….I will edit michael’s post.

    If people post a request here, it will be lost in the other threads as each thread is in alphabetical order.

    Glad your here!!

    Gregg

    #877
    Anonymous
    Inactive

    So where should we be posting requests for service codes? Other threads are exam questions, general chit chat, repair only, etc.

    #878
    Anonymous
    Inactive

    Greetings

    Just post here and we will redirect it … as needed. The date of the original post pre-dates the existence of this site so people had other places to make these requests at the other site.

    regards

    #897
    Anonymous
    Inactive

    Thanks Michael.

    I am looking for service codes for a Zenith R45W46. I have the service manual, but I am pretty sure a service remote is required to enter the menu, unless someone happens to have the IR codes available. Any format is good..hex, RC5, ccf. I can convert them to what I need.

    #898
    Anonymous
    Inactive

    try this … go to the lg section , I put the ccf there

    #1356
    Anonymous
    Inactive

    I worked on a Hitachi 50P410 plasma (circa 2006) and found that neither one of the Hitachi s.m. access methods already listed worked for this panel. I just got lucky finding the method to get into the service menu – and save the changes. (Note: The other 2 access methods both called for pressing the Menu button on the TV – this panel will not access the service menu at all if you try to use the Menu button on the TV)

    Start with the TV turned on.

    On the Remote Control:
    1) Press Menu – wait for the first (short) menu to appear
    2) Press Menu – 8 – Select (in sequence, not at the same time)

    In the service menu, you will find a setting for each color temp setting.

    Select the temp you want to adjust with the up/down arrow keys on the remote. Press Select.

    There are only RGB Drive controls – no Cuts – in the service menu.

    Change Drive values (which are in hex) with < > keys on the remote.

    After changing a Drive value to a new value you want to keep, press Select. Remember the new value you set so you can check again in a minute to see if it was saved.

    Press Exit to return to the previous “page” in the menu system.

    Select Memory Init. Press Select. Return to the color temp setting you were adjusting and look at the RGB Drives again to make sure your new value was saved. If it wasn’t saved, repeat the sequence above again (change the setting, press Select, Exit, Memory Init, Select). This sequence WILL save the new value you set but it doesn’t always work on the first attempt for some reason.

    When you have confirned that your change was saved, use Exit to return to User mode.

Viewing 7 replies - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.